Computer embroidery machine shear line, line short maintenance

Computer embroidery machine cutting line, line short fault troubleshooting method:

A. The length of the short surface line of the embroidery machine's cutting line has A great relationship with the tension of the thread spring and the adjustment of the thread path. If the thread path is tight and the tension of the thread spring is picked up, the surface line of the cutting line will be short.

(1) check the thread, and do not overtighten the thread spring and knob;

(2) adjust the height of the buckle fork, to a high profile will make the surface line longer, this idea is often very effective in actual maintenance

(3) adjust the parameters, the opening Angle, the larger the closing Angle, the longer the surface line.

B. Short cutting line

(1) check the cutting depth, the shallower the cutting depth, the shorter the bottom line;

(2) check whether the thread fork is too tight. The suitable tension of the bottom line is: the thread can be moved by hand after the thread fork is fastened;

(3) adjust the parameters, the opening Angle, the larger the closing Angle, the longer the surface line.

Computer embroidery machine cutting line problem:

First you should try some regular troubleshooting schemes, such as checking whether there is a problem with the scissors, whether there is a problem with the position of the scissors, whether there is a problem with the buckle and insert, whether there is a problem with the hook, etc.In addition, you can also try to adjust the wiring a little bit tighter, spin the hook again.

(1) check the depth of the closing knife, the closing knife is too shallow to cut the line;

(2) change the parameters and check whether the parting Angle is 310-315;

In addition, there are some more special reasons can also lead to broken lines, even at room temperature.Sometimes when the weather is too hot, in the cutting action, the needle is locked, can not go down, the lock needle solenoid valve continuous action twice, resulting in the section line can not be cut.In short, the main reason for continuous line cutting is mechanical and electronic control, the mechanical side is mainly scissors tension is not tight, and electronic control if the electric capacity is not enough, not tight line will also lead to continuous line cutting.